Red Seal Welding Practice Exam

Disable ads (and more) with a membership for a one time $2.99 payment

Enhance your skills for the Red Seal Welding Exam. Get ready with multiple choice questions and in-depth explanations. Achieve your certification with confidence!

Start Multiple Choice Practice Test
Start Flash Cards

Each practice test/flash card set has 50 randomly selected questions from a bank of over 500. You'll get a new set of questions each time!

Practice this question and more.

When shape cutting with PAC, what should your torch angle be?

  1. Perpendicular to the plate

  2. 45 degrees to the plate

  3. Parallel to the plate

  4. 30 degrees to the plate

The correct answer is: Perpendicular to the plate

When shape cutting with PAC, the torch angle should be perpendicular to the plate. This is because perpendicular is the only correct angle for evenly cutting through the material without leaving any jagged edges. 45 degrees and 30 degrees would both result in uneven cutting and parallel would result in no cutting at all. Therefore, it is important to make sure the torch angle is perpendicular in order to achieve clean and precise cuts.

More Questions Like This